Post by Casethecorvetteman on Apr 21, 2015 5:20:44 GMT -5
Hi all, the following is a diagnostic and repair procedure for the CM series and CPC series of Combi-steamer ovens. This came from a CM201, however simular units are fitted to the 61/101/102 and 202, as well as the CPC series, from 61 through to 202.
Fault is oven has tripped main breaker, which can in some cases be reset to restore full function. There is always a reason the oven tripped the breaker and it should be investigated.
The power factor correction capacitor could be the cause of the tripped breaker, and should be checked for physical damage, as seen in the following photo:
The unit contains multiple components, and is non repairable. If it looks like the photo above, it has failed and should be removed.
The oven will function perfectly without this fitted, however it may result in increased power wastage due to poor power factor.
zjjxhzf: hello Gabor i am DLP projectorColor wheel is not accurate，setup memory， the phase angle cant setting for the color wheel ，must use service code.
Sept 19, 2017 1:31:25 GMT -5
mastertech: Hi stranger. Guess you spent your summer cruising on that street bike.
Sept 17, 2017 21:43:54 GMT -5
nashou: Hey everyone, just saying hi ! Hvent been here for a while hope you're all doing well !!
Sept 17, 2017 19:19:25 GMT -5
mastertech: Parts for repair are no longer available.
Sept 11, 2017 19:42:24 GMT -5
mayavi: my pioneer elite VSX-92TXH it freezes until I unplug and then it won't power on until maybe 10 minutes. came to know that its a common problem in this model. any help would be much appreciated......
Sept 11, 2017 13:39:10 GMT -5
jaredjaric: Thanks so much Hulio :), your expertise is very much respected
Aug 20, 2017 9:25:37 GMT -5
Admin: james: you need to post in the thread where your problem is being discussed.
Aug 9, 2017 19:51:54 GMT -5
james: Yes Sir All wiring was connected.
Aug 9, 2017 7:46:15 GMT -5
Admin: I have uploaded a copy of the SM to the digital projector section.
Jan 10, 2017 20:21:56 GMT -5
ducki: sorrry for my bad english ....(google translate
Jan 10, 2017 17:44:21 GMT -5
ducki: I have the same defect as a cp-x4021n you but can not start it ... I did the same trials with ic202 pc102 and still do not like, I make short pin 1 and 2 of the pc102 and PJ light (orange) goes off ... you can help me with a service manual for this PJ? TNX
Jan 10, 2017 17:43:46 GMT -5
jlb12: pwr switch off = 2(0.0) 3(11.7) 6(.04) 7(.04)
Dec 13, 2016 23:27:03 GMT -5
jlb12: No Problem. Thank you for all your help.
Dec 13, 2016 0:20:40 GMT -5