I have temporarily taken the service manual section off line. It looks like I wasn't paying attention when I uploaded all of them and left them all in full edit mode for anyone. Normally I would not care but 2 Marquee files were recently deleted by someone and that also affected the main Marquee download. Now this could of been done accidentally but also could of been on purpose. So I don't want to take the chance with the rest of the files. So I have to redo all of the links which will take some time which I don't have right now. But if someone wants a file just send me a note and I will make it available. Staff still has access if needed also. Sorry for the inconvenience.
Welcome to our forum! Please tell all your friends, relatives and neighbors about this great site.
I hope for it to be everyone's one stop place for repair help and information.
mastertech: Merry Christmas to you too. Not many holiday people around any more.
Dec 26, 2018 14:37:50 GMT -5
stridsvognen: Merry christmas everybody...
Dec 24, 2018 19:10:58 GMT -5
mastertech: Sounds nice. Would love to have many more pictures.
Oct 20, 2018 20:31:04 GMT -5
greg1292: Greetings from Denmark. Lots of ideas knowledge and bucket list. Gabor boards looking very nice indeed
Oct 20, 2018 16:38:34 GMT -5
kevin5418: Anyone has the Velodyne hgs12bg MPS board schematic ? thank U
Oct 6, 2018 0:58:34 GMT -5
mastertech: According to the SM ic711 must be installed with the firmware already in it. It can then later be upgraded. The correct ic is around 50 dollars. If you installed a blank ic it will not work.
Aug 19, 2018 20:01:39 GMT -5
ralph: Hello mastertech, sorry for the delay, if I replaced that IC, I was with short circuit, blocked the 3.3 volt regulator, put a new one but still do nothing, what could I do? Thanks for the reply
Aug 18, 2018 21:48:51 GMT -5
mastertech: Did you replace ic711?
Aug 12, 2018 18:55:42 GMT -5
mastertech: Just to clarify you replaced ic711 (STM32F101ZG), correct?
Aug 10, 2018 20:58:16 GMT -5
ralph: Hello, Mastertech, I'll send it to you
Aug 10, 2018 18:58:46 GMT -5