|
Post by farmerjoe on Jul 23, 2015 20:51:18 GMT -5
OK, I don't have an exact parts list, but I found the defective switching transistor and blown fuse. The local tech then found a capacitor that had drifted in value, and an open resistor that I missed. The driver section was OK, but without replacing the capacitor, the tech said that the new parts would have blown again.
hope that helps, thx.
|
|
|
Post by farmerjoe on Jul 13, 2015 8:39:38 GMT -5
Sorry, I got it repaired locally. Cheap too, $75 total, parts and labor. I actually found most of the problems, but the tech found a couple of parts that I missed, and had stock of the shorted components. Thanks for the help, I'll be posting again I'm sure.
|
|
|
Post by farmerjoe on Jul 5, 2015 15:01:23 GMT -5
Sure, let me dig it out and take a pix. Might be tomorrow before I get to it.
|
|
|
Post by farmerjoe on Jul 5, 2015 12:10:39 GMT -5
I don't want THAT type of tech support. I want to repair the projector! I can solder, and have some basic electronic skills.
|
|
|
Post by farmerjoe on Jul 5, 2015 0:37:56 GMT -5
Sorry, brain dead earlier, I was looking at what a Qualia would cost to replace the boxlight, and got sidetrack. Corrected now..
|
|
|
Post by farmerjoe on Jul 4, 2015 13:46:31 GMT -5
Hi everyone, I've been reading here a bit, and it seems like you all are pretty knowledgeable. I've got a Boxlight Echo X30N that was intermittent for a while, you had to plug and unplug it a few times lately to get it running. Now it's completely dead. Nada. Fuse is OK. Can you help? Service manual maybe?
thanks!
|
|