|
|
Post by mastertech on Feb 26, 2018 20:51:02 GMT -5
I was just looking over the schematics again and you may want to give this a try. Swap resistors R640 and R639 and see if the static changes channels or remains on the current channel. These are thermal resistors and could cause a problem.
|
|
|
|
Post by u2nmg93 on Feb 26, 2018 23:47:10 GMT -5
Just the electrolytic caps. I messed up adjusting the idle current alignment, I kept trying to get 0mv just like the offset instead of between 2.5 to 5. The left channel is at 3mv but the right I can't get above 1mv. I changed the pot out just to make sure and even with a new one still can't get above 1mv. Any ideas?
|
|
|
|
Post by mastertech on Feb 27, 2018 18:36:33 GMT -5
Yes. Did you try swapping those 2 resistors I suggested? |
|
|
|
Post by u2nmg93 on Feb 27, 2018 21:25:26 GMT -5
Yes, still stayed in the right channel.
|
|
rudys
New Member
Posts: 1
|
Post by rudys on Feb 20, 2021 22:20:41 GMT -5
Hi, i know it ‘ s an old post. Any luck on the issue with the static on the right channel when playing? I have exactly the same problem. Thanks
|
|
