|
|
Post by Decibel on Sept 10, 2015 17:01:43 GMT -5
Ahahah Hulio perfetto italiano!
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 10, 2015 17:30:43 GMT -5
Screenshots!
|
|
|
|
Post by Decibel on Sept 11, 2015 3:25:36 GMT -5
The projector is still in my workshop. I hope to raise it to the ceiling as soon as possible. |
|
|
|
Post by Decibel on Sept 12, 2015 10:14:21 GMT -5
Today I tried to make a quick calibration to test all the settings of the projector. I have problems with the convergence of the red that appear very distorted. I realized that the software of Reality 909 don't have the seagull adjustment. And it is the distortion that I see on my projector. Are you sure that the hardware of Cinemax is fully compatible with the software of the BR909?
|
|
|
|
Post by Decibel on Sept 14, 2015 14:41:40 GMT -5
I can not converge the red grid. No problem with the blue. Especially at the corners the horizontal shift of the red is not enough to converge the red on the green. The red grid appear strongly distorted.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 14, 2015 16:11:59 GMT -5
When you attach red to blue convergence and blue to red convergence does the problem shift?
|
|
|
|
Post by Decibel on Sept 15, 2015 2:58:59 GMT -5
There's "blue to red" adjustment.
The blue move to red with extreme values at corners of the screen.
But the red grid is totally distorted.
Somewhere there's a issue that concern red tube or red's circuit.
|
|
|
|
Post by Casethecorvetteman on Sept 15, 2015 3:16:33 GMT -5
He means plug the red covergence yoke into the blue outputs to see if its the board or the yoke.
Check for bent pins too.
|
|
|
|
Post by Decibel on Sept 15, 2015 4:02:24 GMT -5
I cheked pins, they're ok.
Today I'll try to swap blue and red yokes.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 15, 2015 6:27:16 GMT -5
Could be that the wave created on the systemboard is wrong or that the convergence board is changing it?
If it does not go to blue than could it be bad scheimpflug? Are the corners sharp focussed?
|
|
|
|
Post by Decibel on Sept 15, 2015 6:41:37 GMT -5
No scheimpflug or focus problems. The horizontal lines of the grid in the corners are strongly distorted.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 15, 2015 9:06:33 GMT -5
So when you unplug the convergence coil for red the distortion gets less?
|
|
|
|
Post by Decibel on Sept 15, 2015 9:08:13 GMT -5
This evening I'll try all.
|
|
|
|
Post by Decibel on Sept 15, 2015 13:08:02 GMT -5
Tried to swap defl/conv coils red <--> blue.
The issue remain to red.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 15, 2015 13:46:19 GMT -5
Can you make a picture to give an idea of the problem?
|
|
