Post by Casethecorvetteman on Mar 10, 2016 11:19:50 GMT -5
Hi all, ive now got a few items with reasonably fine pitch chips that may need their solder joints going over.
Some of these items tend to go bad after warming up, and others come good when they warm up.
What is the best and easiest way to reflow these joints without doing any damage?
On some items in the past ive just hit them with the hot air gun set on a lower air speed and around 300°C, but these items im looking at here dont really have enough solder on some of the legs.
Some of these items tend to go bad after warming up, and others come good when they warm up.
What is the best and easiest way to reflow these joints without doing any damage?
On some items in the past ive just hit them with the hot air gun set on a lower air speed and around 300°C, but these items im looking at here dont really have enough solder on some of the legs.
