Onkyo TX-NR616, constantly clicking, no display

I have put all the screw back for the power supply board that secures it to the chassis and I put two screws securing the hdmi board to the chassis 

I tested ground from pin 3 from jl901b to the chassis and it was a good ground. Near to the same as when I touch my meter probes together. 
I get voltage on the cable coming from the power supply  board that connects to the hdmi board 
Below are measurements taken from when the cable is plugged into the hdmi board 
Pin 1 is 12v but when relay clicks it goes down 
Pin 2 is 0v
Pin 3 is GND 
Pin 4 is 12 v
Pin 5 is 0v

I read that if I put jumper wire from Pin 1 and Pin 3 on jl901b which is on the hdmi board the relay should latch but with the transformer cable removed I tried this and got nothing 
I tested the relay and got about 300 ohms And the relay is clicking 
I am really stuck and will appreciate some detailed help from this amazing community Please 

Many Thanks 

I have been doing more voltage measurements. The results are below

I tested q7018

pin 1 is gnd,
pin 2 is 4.8v
pin 3 is 3.3v

also tested q7019

pin 1 is gnd,
pin 2 is 11.89v - 11.90v
pin 3 is 5.6v

Nothing is getting hot and i cant see any bulging caps

Please will really appreciate all the help from this forum
Many Thanks in advance