|
Post by garent on Aug 14, 2015 14:32:59 GMT -5
Jeremy,
Thanks for helping, If I understand your question, the connector that's normally on the projector side is actually fused inside the lamp connector part. THe one wire was burnt through and the other just had a few strands left holding it on.
|
|
|
Post by garent on Aug 13, 2015 20:21:16 GMT -5
I replaced my worn out bulb with a new one, and when I turned it back on it kind of "sizzeled" and there was a puff of smoke. *bad sign* I shut it all down and tried to remove the bulb but it was stuck. Projector actually worked for a few days despite an occasional burnt electrical smell, until it finally shut down. Removed cover to find the bulb connector melted and wiring harness stuck together. Trying to figure out if I just need a new lamp connector, but can't find part #'s. Thanks for the help! Garen
|
|