nick
New Member
Posts: 8 
|
Post by nick on May 22, 2015 12:55:10 GMT -5
If there is a chance to fix this issue, I'm fine with that. Could you please let me know how the rest is done. Thanks!
|
|
|
|
Post by mastertech on May 27, 2015 11:57:49 GMT -5
Ooooooops, I forgot about this. Not indoors much with summer here now.
Master reset: With receiver in standby press and hold the setup
and standby/on buttons. Display shows reset no., press enter.
using right and left arrow select reset, then press enter,
display shows reset?OK, press enter. Should display OK.
|
|
nick
New Member
Posts: 8
|
Post by nick on Jun 7, 2015 10:55:25 GMT -5
Did a master reset based and the problem still reappears. One thing to note, once the connection goes down, if I leave it alone, it comes back at some point by itself. Does this intermittent failure perhaps mean bad network port on the receiver? For whatever reason, it loses connection to the router. Thanks!
|
|
|
|
Post by mastertech on Jun 7, 2015 21:28:28 GMT -5
Did a master reset based and the problem still reappears. One thing to note, once the connection goes down, if I leave it alone, it comes back at some point by itself. Does this intermittent failure perhaps mean bad network port on the receiver? For whatever reason, it loses connection to the router. Thanks! Well at this point, if you believe it is most likely in the receiver, the only thing I can suggest is the freeze fix. Even though it is not freezing and if it has never had the fix done, I have seen many different symptoms fixed by the repair. It would still be a gamble but probably cheaper then replacing boards or trying to test it out which would be futal if it was not a component failure. I would still be more comfortable if you could take your receiver to someone else's house and try it on their internet using all their components and just your receiver. |
|
|
|
Post by nickolee90 on Aug 27, 2015 19:38:49 GMT -5
I have a VSX-94THX that freezes and locks up after being on for a couple minutes. I cannot change the input, volume or any settings when it freezes. I have to unplug the unit, but it takes it a few minutes after being plugged back in to allow me to turn it back on. Any suggestions?
|
|
|
|
Post by mastertech on Aug 27, 2015 21:16:05 GMT -5
You have to send some boards for repairs.
|
|
|
|
Post by lonnyhedge on Oct 21, 2015 18:27:56 GMT -5
hi i to would like to get my pioneer fixed someone help please
|
|
|
|
Post by lonnyhedge on Oct 21, 2015 19:15:42 GMT -5
looking for someone to help me with my pioneer vsx-92txh freezing up
|
|
dood
New Member
Posts: 1
|
Post by dood on Jan 22, 2017 17:29:26 GMT -5
Ok, Yes this is the common problem. I am going to PM you some information. I too am having this issue. Could you send me info for repair ? |
|
|
|
Post by stuart on Jan 22, 2017 18:30:03 GMT -5
Assuming he's still performing the board repairs, this is who repaired my 94THX with the freezing problem a couple of years ago and it's worked perfectly since.
I highly recommend emailing him, he will provide instructions for board removal and where to ship it etc.
|
|
|
|
Post by mastertech on Jan 23, 2017 11:49:04 GMT -5
Unfortunately parts for this repair are no longer available so there is no longer any repair service.
|
|
nashou
Unmoderated Off Topic
Tech in Training.....
Posts: 1,239
|
Post by nashou on Jan 25, 2017 8:52:34 GMT -5
Unfortunately parts for this repair are no longer available so there is no longer any repair service. Well that sucks !!!  |
|
|
|
Post by pjstone on Oct 9, 2017 14:31:51 GMT -5
Ok, Yes this is the common problem. I am going to PM you some information. hi I have a Pioneer Elite VSX-92TXH that ids freezing up. can I still get this repaired or get the parts to fix it? thanks |
|
|
|
Post by mrfixit on Jan 26, 2018 18:58:17 GMT -5
Are the parts requires to fix the 92txh available at all? I'm pretty handy w/ circuit board repairs. It looks like this thread might be dead in the water...hasn't been any activity lately.
|
|
